Naviglio Error Codes

Light Signals

Behavior

Solution
Machine in stand-by. Press the "Power" button to turn on the machine.
The machine is performing the rinse cycle. The machine ends the cycle automatically. Press the “Coffee ” or "Hot Water " button to stop the cycle before the end.
The machine is heating up for beverage brewing Allow the process to complete.
The machine is ready for use. Allow the process to complete.
The machine is in the hot water dispensing phase. Allow the process to complete.
The machine is brewing one cup of espresso. Allow the process to complete.
The machine is brewing two cups of espresso. Allow the process to complete.
The machine is brewing one cappuccino. Allow the process to complete.
The machine is programming the amount of espresso to be brewed. Allow the process to complete.
The machine is programming the amount of cappuccino to be brewed. Allow the process to complete.
The machine is dispensing steam. Allow the process to complete.
You need to descale the machine. Start the descaling cycle. If not descaled regularly, the machine will stop working correctly. Any malfunction will not be covered by the warranty.
The machine is in the descaling phase. Press the “CALC CLEAN” button to pause the cycle.
Machine "PAUSED" during the descaling cycle. Press the “CALC CLEAN” button to start the cycle.
Prime the circuit. Fill the water tank with fresh water and prime the water circuit as described in the “Using the Machine for the First Time” chapter.
Close the service door. Insert the brew group. Make sure that all components have been correctly inserted and closed.
The coffee bean container is empty. Fill the coffee bean hopper with coffee beans and restart the brewing cycle.
Coffee pucks container not inserted. Empty the coffee pucks container and wait for the LED light to flash slowly before reinserting it.
The coffee pucks container is full. With the machine turned on, empty the coffee pucks container and the drip tray. If the coffee pucks container is emptied with the machine turned off, or when the indicator light is not illuminated, the coffee cycle counter is not reset. In this case, the indicator light indicating to empty the coffee pucks container may illuminate even when it is not full.
The water tank is empty. Fill the water tank with fresh water.
  A fault has occurred in the machine and espresso, water or steam cannot be dispensed. "Turn off the machine, wait for 30 seconds and then turn it on again. Try this 2 or 3 times.